Rebel S3 Technical Boots

The S3 Technical Boot is ISO 20345 and SABS approved. These specialized workboots have been designed to keep your feet safe in the harshest of conditions. Features of this technical workboot include a full grain, high quality buffalo leather with S3 water resistant coating, a dual density polyurethane sole with anti-penetration, and the widest carbon steel toe cap.

• Full grain high quality buffalo leather with S3 water resistant coating
• Dual density polyurethane REBEL Safetygear sole with anti-penetration
• Widest carbon steel toe cap
• Breathable and abrasion resistant Taibrelle lining
• Fully padded collar and tongue for additional comfort
• Nickel-free D-rings

Materials:

• Upper: Full Grain High Quality Buffalo Leather c/w with S2 Water Resistant Coating
• Lining: Breathable and Abrasion Resistant Tai-brella (Equivalent to Cambrelle)

Eyelet:

• Nickel-free Eyelets

Special Features:

• Hi-Viz “In the Dark” Safety Strip for added visibility

Sole:

• Dual Density Poly Urethane Sole- injection moulded
• Inner Sole - Biagioli IBITECH 252 2mm Foam Insole Board
• Temperature Maximum 90ºC (degrees Celsius)
• Oil and acid resistant Dual Density PU
• Slip Resistance - Tested to SATRA PM144 1992 and meets these requirements
• However, care should always be taken on wet or oily surfaces
• Crack Resistance - Tested to 30,000 flex cycles
• Steel mid sole for anti-penetration
• S2 Water resistant upper

Toe Cap:

• Steel Toe Cap
• Tested to an impact resistance of 200 Joules

Anti Static Properties:

• Product is anti static. If application is life critical additional consultation with product expert is required. Electrical resistance can be significantly changed by flexing, contamination or moisture. Introduction of additional inner sole reduces static resistance